11 Winter Home Plumbing Tips

Every winter season many homeowners suffer the disaster of a plumbing problem that might be avoided or the damage minimized by taking a couple of inexpensive preventative measures.  Plumbing Repair Boston want to make sure you will not face an emergency situation this cold season!

1. Insulate all areas that could enable cold icy wind to blow on pipelines.

2. Insulate all exposed pipelines particularly in crawl spaces and the outside walls of the house.

3. Use pipe wrap and heat tape in locations that are specifically vulnerable to the cold. (I.e. the northern side of your house).

4. Put in a pressure reducing valve if your home has 70 pounds per square inch of pressure or more. High water pressure can shorten the life of every plumbing part in your home and could additionally burst lines and reason hookups to fail. If you hear banging in the pipelines after you turned off a valve, operate a washing device and/or dishwasher then you have a problem.

5. Make certain all hose pipe bibs are off and drained.

6.  If your hot water heater is older than 10 years think about changing it. They rust at the bottom and could effortlessly drip swamping your basement.

7. It is necessary to know where the primary water valve is to your house. Make sure it is easily found and tagged for identification. If you need to close down the water in your residence for any type of explanation then you will have the ability to easily access it.

8. Have the number of a reliable and qualified plumber convenient for emergencies.

9. Install inexpensive water alarm systems in your basement, next to the water heater, next to the washing equipment, the dish washing machine and under your sinks.

10. Install a flow stop valve on your major water line as this device will notice a water crack and immediately shut down the water to your home.

11. Change washing machine hoses. If they have actually not been altered within five years then there is the possibility that they can effortlessly burst specifically if your house has high water pressure. () 70 psi).

How To Blow Out Water Lines From Freezing During Winter

 

“If you have an outside bathroom, pool slide , or even a irrigation system that is in need of blowing the water from the lines you can either use a air compressor if you no what you are doing or you can hire a licensed professional to do the job for you. Although its not recommended for you to try to blow out your own sprinkler lines it can be done with a high CFM air compressor which is much bigger then the average homeowner or center will have. If you you are blowing out swimming pool lines or other short runs you can use a smaller air compressor with a low psi so you don’t wind up popping fittings apart with t much air pressure.”

The Fairfax County Government offers this tip as well:

“If you are vacating your home because you have lost your heat source, locate and turn off your main water cutoff valve. After the valve is turned off, open a faucet on each level of your home to allow for expansion should the undrained water freeze. If you are staying in your home or will be monitoring your home frequently, allow a faucet to drip cold water slowly. At a minimum, the dripping faucet should be the one that is the greatest distance from your main water cutoff valve. Consider allowing a slow drip in areas that are least protected from the cold (basements, crawl spaces, attics and garages).”  (read more…)

Please  take the time to examine your plumbing system and visually evaluate all your pipes, valves, and drain lines. If you need aid in examining your plumbing system give us a phone call at Plumbing Repair Boston.